The pistol was designed by Heinrich Ortgies, said to have been a German by birth but who was a resident of Liege, Belgium, until about the close of World War I. This particular one has the 4th style slide, made around 1920-1921.The Ortgies pistols are unique in design, although inevitably they have some features in common with other automatic pistols. Taking apart my Ortgies Deutsche Werke 7.65 (32acp) pistol. I am looking for parts as well, mine is missing the left side grip and the clip. I have seen valuations that run the gammit from 100 and up. I have a Deutsche Werke Werk ERFURT 7.65 mm (32 cal.) Serial 90237.78678, 7.65mm caliber, 3 1/4-inch barrel with - Available at 2021 December 12 Arms & Armor.Although the Model 1920 Ortgies was only made for 3 years by Deutsche Werke production being forced to stop due to the Treaty of Versailles there were quite a few made. 222).Deutsche Werke Ortgies Semi-Automatic Pistol. 1910, but internally it is quite different (Fig. The pistol has an outward appearance similar to the F.N.When the grip safety is in the „in" position the gun can be fired by pulling the trigger, but when it is in the „out" position pulling the trigger alone, without depressing the safety, will not cause the gun to fire. This pistol has but one safety and this is a grip safety which operates in an unconventional manner. The barrel is pivoted at the rear end and can be removed by turning it at right angles, in which position it can be slid out.
![]() This firm purchased the rights, tools, designs, and unfinished parts from Ortgies and Co. Pistol seems to have started in 1920, and because the weapons were attractive in appearance and were well made they soon attained popularity, which fact naturally attracted the notice of other manufacturers, including Deutsche Werke, A.G., of Erfurt. Production of the 7.65 mm. To manufacture his pistol. There is also a Crown with an N Underneath below the Ortgies Patent.Some time soon after World War I, Ortgies went to Erfurt where he organized the firm Ortgies and Co. Any grip safety which does not require a substantial pressure to depress it is dangerous, and obviously more so when it automatically locks itself in this position when it is depressed-as is the case with the Ortgies.Signed Deutsche Werke Werk Erfurt 7.65 mm, Serial Number 133803 and Ortgies Patent. Browning Short (.380) was brought out, but this did not enjoy the popularity attained by the smaller models. A short time later the 9 mm. Model, because soon after Deutsche Werke took over the business a pistol of this caliber was produced. Caliber was the only one produced by Ortgies and Co., but apparently they had been tooling up for the 6.35 mm. This was actually done later by Deutsche Werke.Dealers lists of 19 include the 6.35 and 7.65 mm. Barrel, interchangeable with the 7.65, but does not infer that it was in production at that time. Model, listing it as available, and it also mentions but does not describe the 6.35 model. Calibers until late in the 1920's.An Ortgies manual, thought to have been issued in 1919, describes the 7.65 mm. Deutsche Werke continued the manufacture of the pistol in the 6.35 and 7.65 mm. Or its successor, Deutsche Werke, A.G., is not known, but there were at least upwards of 250,000 and possibly more. Caliber for the first time in about March or April of 1922.The total number of Ortgies pistols made by either the original Ortgies and Co. From this it seems likely that the pistol was furnished in the 9 mm. Caliber, as being in production, is in the AKAH Catalog of May 1922. The first mention found of the 9 mm. An Ortgies instruction booklet dated February 1922 describes the smaller-caliber pistols but does not mention the 9 mm. Deutsche Werke Ortgies S Serial Numbers AtProbably started their serial numbers at No. It appears that Ortgies and Co. No Ortgies pistols with grips of material other than wood have been seen. The former has plain wood grips while the latter has wood grips with the HO (Heinrich Ortgies ) monogram. 195, and the highest number seen on a pistol similarly marked is No. (7.65 mm., of course) is No. ![]() This monogram has not been observed on any of the large number of pistols examined, and whether it was actually used or not is not known. A still different monogram is seen in the advertisements of the Ortgies pistol in the AKAH Catalog, consisting of the capital letters DW, the D being above the W. This monogram usually appears also on the slide between the words Deutsche and Werke. Because of the presence of these letters in a monogram on the grips, the letters standing for Oesterreichische Werke-gws-Anstalt, a firm which apparently started up following World War 1. The pistol is called the O.W.A. Caliber pistol bears some resemblance to the Steyr but is not the same and was not made under any Pieper patent. The first two bear only the words PATENT ANGEMELDET (Patent Applied For) and the date on the left side of the slide and the words „MADE IN AUSTRIA" on the right. 5626, 5906, and 18,315 (all dated 1922) are identical, with the exception of markings. In the Steyr, only the barrel tips up. How long it was in operation is not known.The pistol is different from the Steyr in that, while hinged at the front end, the whole slide tips up when the catch is released. And may have been manned by former employees of that firm. Is unnecessarily complicated. Like most of the nonBrowning types of pistols, the O.W.A. 37,161, dated 1924, (illustrated in the Pistolen Atlas) shows some differences in construction.The unlocking lever is mounted on the right side of the slide instead of the left, and a lever has been substituted for a sliding catch to operate the mechanical safety. KULTURSTAATEN" on the left side of the slide and nothing on the right side. 223 to 225).Despite its clumsy, awkward appearance and apparent lack of balance, the pistol was demonstrated to the U.S. Of Berlin and they not only agreed to produce the pistol but also put him in charge of production, which began in 1893 (Figs. He succeeded in interesting the Ludwig Loewe Co. Unable to interest any American arms manufacturer he took his ideas to Germany where both he and his ideas met a quite different reception. Configure the barracuda vpn client for mac os x1894 cartridge and is sometimes spoken of as the forerunner of the 7.63 Mauser cartridge. This is referred to as the Borchardt M. In any case, however, it was not considered suitable as a military side arm.Borchardt had designed a new cartridge for his pistol, in 7.65 mm. When attached to the stock, with which the pistol was provided, the balance and appearance were greatly improved, as was the accuracy of fire. The Board did admit that the pistol had advantages over the service revolver then used. A number of weaknesses in construction were noted. ![]()
0 Comments
Leave a Reply. |
Details
AuthorTanya ArchivesCategories |